Wind sensor n/t 1Z 100-265V AC IP65 STR-W Destiny The STR-W controller with an external wind sensor is designed to monitor current wind speed If the wind speed exceeds the specified threshold, the internal relay shall be connected In combination with the STR-3 or STR-4 roller blind controllers, it allows to build a system in which window blinds or rolled awnings are closed in case of too strong wind. ActionThe controller works in two modes: Continuous mode If the wind speed exceeds the specified value, the internal contact of the relay closes and remains closed for the entire duration of the wind gusts In combination with the STR-3 and STR-4 roller blinds controls, this mode ensures that the roller blinds are closed when strong winds occur and locked in a closed position until the wind stops. The range of wind speed control at which the alarm is reported shall be smoothly adjusted from 30 km/h (entry A) to 80 km/h (entry B) Pulse mode If the wind speed exceeds the specified value, the internal contact of the relay closes for a time of approx. 1.5 s passing to the roller blind controllers a one-time closing order In conjunction with the STR-3 and STR-4 roller blinds controllers, this mode ensures that the roller blinds are closed when strong winds occur, but later the user has the ability to raise the roller blinds at any time The range of wind speed control at which an alarm is reported shall be smoothly adjusted between 20 km/h (heading D) and 70 km/h (heading C) Technical data:Controller power 100÷265 V AC contact closing the internal. relay gives the N-line level to the OUT output Max load (AC-1) 2A / 230 V power consumption standby < 0.2 W Work <0.6 W operating temperature (no condensation) -15÷50 °C max. tightening moment 0,4 Nm signaling power supply LED green U strong wind and relay connection LED red OUT connection screw terminals 2,5 mm2 dimensions 67×50×26 mm Isolation (power-sensor-stick) ≥ 500 V installation two screws into the ground degree of protection IP20 Windmill dimensions Ø80×85W mm wire 2× 0,25 mm2 / l = 5 m mounting screw N6 mounting bracket steel flat plate (L profile) 150×70×3 mm degree of protection IP65